Consult International Marine’s INTERGARD brochure on NauticExpo. Page: 1/4. International Intergard is a high build, two component epoxy, pigmented with lamellar micaceous iron oxide for enhanced corrosion resistance and. Intergard is a two-pack epoxy coating, containing micaceous iron oxide, which can be overcoated after extended periods. Used as a.
|Genre:||Health and Food|
|Published (Last):||8 November 2018|
|PDF File Size:||16.64 Mb|
|ePub File Size:||3.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
Year of Establishment Where necessary, remove weld spatter and smooth weld seams and sharp edges.
Open the catalog to page 3. Consult your International Paint representative for specific recommendations.
Anti Corrosive Paints in Mumbai. The question has been intergarr sent. Ideally suited as a damage and handling resistant coating which can be factory applied and then overcoated on site with minimum surface preparation.
Apply in good weather. The minimum purchase order quantity for the product is 1. Ideally suited as a damage and handling 040 coating which can be factory applied and thenovercoated on site with minimum surface preparation. For example, an over applied epoxy MIO may not have its usual “textured” surface and will no longer be overcoatable after ageing unless it is abraded.
Application by brush is recommended for small areas only.
The incorporation of plate-like micaceous iron oxide pigment both increases the barrier effect andimproves long Proper ventilation and protective measures must be provided during application and drying to intergadd solvent vapour concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Multiple coats may be required to achieve specified film thickness.
Always mix a intrgard unit in the proportions supplied. Material is supplied in 2 containers as a unit.
Do not exceed pot life limitations. Call Send a quick message. This product is no longer in stock. Use in interagrd with the standard Worldwide Marine Specifications.
INTERGARD – International Marine – PDF Catalogs | Documentation | Boating Brochures
Read and follow all precautionary notices on the Material Safety Data Sheet and container labels. Typical Coverage per coat 5. If you do not fully understand these warnings and instructions or if you can not strictly comply with them, do not use this product.
Products Marine Coatings Marine chemicals Marine lubricants. Test performance interbard were obtained in a controlled ontergard environment and International Paint makes no claim that the exhibited published test results, or any other tests, accurately represent results found in all field environments.
Frequency of cleaning will depend upon amount sprayed, temperature, relative humidity and elapsed time, including any delays. Consult your local International Paint representative for specific recommendations. Marine Coatings Marine chemicals Marine lubricants.
International Intergard is a intervard build, two component epoxy, pigmented with lamellar micaceous iron oxide for enhanced corrosion resistance and improved overcoating properties after ageing. Optimum performance is achieved when Intergard is applied over blasted steel.
Do not allow material to remain in hoses, gun or spray equipment. It is good working practice to periodically flush out spray equipment during the course of the working day.
Clean all equipment immediately after use with International GTA When overcoating with IntergardIntergard and Intergard the anticipated level of intercoat adhesion can only be achieved in “extended” overcoating situations interhard Overcoating information is given for guidance interyard and is subject to regional variation depending upon local climate and environmental conditions.
Please ensure you refer to all datasheets for full application information.