ICLL 1966 PDF

The International Convention on Load Lines (CLL), was signed in London on 5 April , amended by the Protocol and further revised in LL69 Interpretation to ICLL Reg. Rev.1 July LL70 Corrosion Margin for Hatch Cover Design. Jan LL71 Similar Stage of. Rev.1 Nov LL Position of freeboard deck on float on/float off barge carriers. (Regulation 3(9)). Rev.1 July LL Interpretation to ICLL Reg.

Author: Sakora Zulkijar
Country: Australia
Language: English (Spanish)
Genre: Relationship
Published (Last): 11 February 2017
Pages: 51
PDF File Size: 18.38 Mb
ePub File Size: 4.32 Mb
ISBN: 123-4-71862-516-4
Downloads: 73941
Price: Free* [*Free Regsitration Required]
Uploader: Samucage

Standard height in m L m Raised quarterdeck All other superstructures 30 or less 0. No certificate shall be extended for a period longer than 3 months, and a ship to which an extension is granted shall not, on its arrival in the port in which it is to be surveyed, be entitled by virtue of such extension to leave that port without having a new certificate.

These lines shall be horizontal lines millimetres 9 inches in length and 25 millimetres 1 inch in breadth which extend abaft unless expressly provided otherwise, and are at right angles to, a vertical line 25 millimetres 1 inch in breadth marked at a distance millimetres 21 inches abaft the centre of the ring as illustrated in figure 3.

Portable beams 6 Where portable beams for supporting hatchway covers are made of mild steel the strength shall be calculated with assumed Loads not less than 1.

Permanente link Article 26 Communication of Information Ingangsdatum: However, in order that such special freeboard may be granted and used, the timber deck cargo shall icll with certain conditions which are laid down in Regulation 44, and the ship itself shall also comply with certain conditions relating to its construction which are set out in Regulation Coquimbo and Santos are to be considered as being on the boundary line of the Tropical and Summer Zones.

Place of issue of certificate.

International Convention on Load Lines

Where the form at the lower part of the midship section is of a hollow character, or where thick garboards are fitted, the distance is measured from the point where the line of the flat of the bottom continued inwards cuts the side of the keel.

  CATERPILLAR 525B PDF

Permanente link Article 34 Languages Ingangsdatum: Article 22 Privileges Ingangsdatum: When a ship departs from a port situated on a river or inland waters, deeper loading shall be permitted corresponding to the weight of fuel and all other materials required for consumption between the point of departure and the sea. This certificate is valid until Such certificate shall be subject to a renewal, endorsement and cancellation procedure similar to that provided for an International Load Line Certificate under this Article.

It has long been recognized that limitations on the draught to which a ship may be loaded make a significant contribution to her safety.

The survey shall be such as to ensure that the arrangements, materials and scantlings fully comply with the requirements of idll present Convention. The minimum area for each well on superstructure decks shall be one-half of the area given by the formulae.

EngvarB from May Use dmy dates from May Ships constructed on or after 1 July shall, as a minimum, comply with the requirements of part A of the IS Code. Amidships is at the middle of the length L.

International Convention on Load Lines (ICLL )

A ship which is designed, constructed and maintained in compliance with the appropriate requirements of an organization, including a classification society, which is recognized by the Administration or with applicable national standards of the Administration in accordance with the provisions of regulationmay be considered to provide an acceptable level of strength.

Article 14 Initial and Periodical Surveys and Inspections 1 A ship shall be subjected to the surveys and inspections specified below: The tarpaulins shall be waterproof and of ample strength.

The forward and after perpendiculars shall be taken at the forward and after ends of the length L. Permanente link Permanente link Article 22 Privileges Ingangsdatum: Stability 10 Provision shall be made for a safe margin of stability at all stages of the voyage, regard being given to additions of weight, such as those due to absorption of water and icing and to losses of weight such as those due to consumption of fuel and stores.

  APENDICITIS AGUDA FISIOPATOLOGIA PDF

Views Read Edit View history. Permanente link Article 31 Suspension Ingangsdatum: The corresponding Loads on hatchways in position 2 may be reduced to 0. The distance from an end bulkhead of a superstructure to the first eye plate shall be not more than 2 metres 6.

Ga direct naar Inhoud of Menu. For the guidance of Administrations the following limits may be regarded as satisfactory: Doorways in such deckhouses or companionways shall be fitted with doors complying with the requirements of Regulation 12 1.

Article 06 Exemptions Ingangsdatum: In all cases values at intermediate lengths shall be obtained by interpolation.

Permanente link Permanente link Article 13 Survey, Inspection and Marking The survey, inspection and marking of ships, as regards the enforcement of the provisions of the present Convention and the granting of exemptions therefrom, shall be carried out by officers of the Administration.

Winter freeboard 5 The minimum freeboard in winter shall be the freeboard obtained by an addition to the summer freeboard of one forty-eighth of summer draught, measured from the top of the keel to the centre of the ring of the Load line mark.

Type “B” ships 5 All ships which do not come within the provisions regarding Type “A” ships in paragraphs 2 and 3 of this Regulation 9166 be considered as Type “B” ships. Position 2 – Upon exposed superstructure decks situated abaft a quarter of the ship’s length from the forward perpendicular.

VPN