The SEX is an S series solid body electric guitar model introduced by Ibanez in It was initially produced in Korea and then later in Indonesia. There’s no way a guy who does a couple guitar setups every day of the year would do a better than someone will with instructions from the. For over 18 years, Ibanez RG guitars with Edge double locking sys- tems have been SEX MOF. • 3pc Wizard II Manually Adjustable Zero. Point System.
|Published (Last):||26 April 2017|
|PDF File Size:||14.75 Mb|
|ePub File Size:||3.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
Products and specifications are subject to change without notice.
Solid Body Electric Guitars. Loosen the pressure pad lock screws on the top lock with a 3. Tighten the string stopper bolt. Insert the tremolo arm into the arm socket and firmly push down until the arm snaps into place Note: Intonation adjustment is usually necessary when new strings are fitted it can also be affected by the angle of the tremolo unit.
Turn the notched wheel 4 To raise or lower the bridge. Occasionally, there are times when the neck may need adjustment.
To reduce the torque, remove one bushing on the lower side. To allow the arm to swing freely. Retune the guitar to the proper pitch and check the angle.
The purpose of this is to accommodate for different tunings or different gauges of strings. Play the harmonic at the 12th fret, compare it to the fretted noteat the 12th fret, these notes should read the same on the tuner. Wind the string around the tuning machine and tune to pitch 6. All lbanez guitars use A for a standard pitch.
This adjustment should be performed periodically and only by qualified repair personnel. The truss rod is adjustable at the headstock using as allen wrench or an adjustment wrench. The tremolo arm is placed in the hole in the bridge plate and inserted into the threaded block.
Raise or lower the tremolo to the desired string height using a 3mm allen wrench. Play the harmonic at the 12th fret, compare it to the fretted note at the 12th fret, these notes should read the same on the tuner.
| Wiring Diagrams
The height adjustment of the tremolo can be set by using the two 4mm adjustment screws 2 on manua side of the tremolo unit.
The height adjustment of the tremolo can be set by using the two 3mm adjustment screws on either side of the tremolo unit. Insert the mamual arm into the arm socket and turn the Arm torque adjustment nut A clockwise until it stops.
Make sure the truss rod is properly adjusted before adjusting the action. On the bass plate there are two holes for each saddle lock down screw.
To check the intonation: Using a Phillips head screw driver, turn the Spring tension adjustment screw and adjust the length of the spring. Over adjustment can result in damage to the instrument and will no be covered under warranty. If the intonation is still not correct repeat steps 1, 2 and 3.
Cut off the ball end of the new s20ex above the string winding and insert the end of the string in between the main saddle and the Amnual holder block. To adjust the string height of the saddles use a 1. Height adjustment is made by adjusting the 2mm allen screws on either side of the bridge.
When the guitar is properly adjusted, tighten the top lock pressure pad screws. Tremolo Angle Adjustment The tremolo system should sit parallel to the surface of the guitar body, as shown in the illustration. Remove the tremolo cavity cover plate from the back of the body. All guitar necks are subject to great stress as a result of string tension, humidity or changes in climactic conditions.
Loosen the heigth adjustment screw 5 ibahez both sides of the bridge using a 2 Phillips. After changing the desired strings retune all the strings to the proper pitch and tighter the top lock pressure pad screws.
Note For ease in retuning.