Futaba GY Pdf User Manuals. View online or download Futaba GY Instruction Manual. Nstruction, Anual • Read online or download PDF • Futaba GY User Manual. The chart below works for almost all helicopters but you should consult your helicopter manual if you are not sure. Note that I have seen.

Author: Nazilkree Shagrel
Country: Kazakhstan
Language: English (Spanish)
Genre: Health and Food
Published (Last): 4 June 2011
Pages: 289
PDF File Size: 19.20 Mb
ePub File Size: 9.25 Mb
ISBN: 553-7-41293-787-2
Downloads: 9157
Price: Free* [*Free Regsitration Required]
Uploader: Shakazuru

Release the button and you will see the gyro light repeat a ‘1 blink’. Power up the radio and the receiver. The goal is with the rudder stick centered, the tail control lever and the servo arm are both 90 degrees to the tail control rod.

Note the color of this light. You should make the decision based on what your flying style is. Blue – Standard Response default selection Red – Fast Response for lightweight small helis with a fast tail servo Violet – Slow Response for scale helis To change the mode, quickly press and release the button on the gyro.

Options Quote message in reply?

On my miniTitan you can see in the right picture that the tail servo is mounted to the tail boom. So it is important to make the maanual on the bench so you do not risk damaging the helicopter. I was mmanual my buddy and he wanted me to hover it, so as soon as I did, the tail was super wobbly. For the first second the light will blink slow. The black wires will be away from the labels.


Register Now In order to be able to post messages on the HeliFreak forums, you must first register. One direction will set the gain value for heading hold and the other will be for standard rate. To get the two Futaba connectors into your Spektrum receiver you will have to trim the flat piece that sticks out on the side.

Verify the gyro is in Heading Hold mode, light on the gyro is Red. The light on the gyro will turn solid Blue. When you move the rudder stick to the right, it will move the trailing edge of the tail blades to the right side of the helicopter. Wait three seconds for it to initialize.

GY Setup – HeliFreak

Turn on the radio then connect power to the receiver. Please provide as much info as you can. Now flip the switch down fy520 confirm the gyro is now solid blue. On the small helicopters a gain of around 50 is normal. This will set it up for the next step. Hold the button on the gyro for 2 seconds to go to the next function. Use an exacto knife to shave this off. One direction will be blue and the other direction is red.

At the left, look at the top picture. When the stick is centered it needs to be a solid color red HH, blue non-HH. If not, then enter setup mode of the gyro hold the button for 3 seconds. Make sure you pay attention to the polarity of the receiver pins.


FUTABA GY520 Instruction Manual Page 23

This will tell you the current mode the gyro is in. Next check that the gyro responds to the rudder stick.

The gyro will repeat a ‘1 blink’. Thank you so much!

For a to class mount it about This will save the setting. Use the ‘clear’ button to set the values to zero.

Remove Advertisements Sponsored Links. This will set how fast the helicopter rotates. Because this is on a small heli and I wanted to keep the wiring short I made my own.

Futaba GY520 User Manual

The blue label on the gyro needs to be either up or down. Next disconnect the rudder link from the tail servo. Place the servo arm on the servo spline. You should set it up in rate mode, even if you only intend to fly it in HH mode which most of us do. If all of this checks good then continue to step