Grandstream HandyTone is an “All-In-1” VoIP IAD based on SIPstandard. Built upon Grandstream’s innovative technology，HandyTone features superb. Grandstream HandyTone is a multi-port, all-in-one Analog telephone adapter. It has one RJ11 FXS port(Telephone device), one RJ11 FXO port(Phone line). Grandstream Handytone Setup Guide. Grandstream Handytone ATA; Grandstream Handytone ATA; Grandstream Handytone ATA; Grandstream.
|Published (Last):||11 May 2011|
|PDF File Size:||6.16 Mb|
|ePub File Size:||13.41 Mb|
|Price:||Free* [*Free Regsitration Required]|
For example IP address: Update the firmware of your Grandstream device to the recommended firmware version. It also supports different codecs: Handytone users Handytone must be grandsgream into the LAN and connected to an analogue phone press the button on the Handytone, you should hear a menu prompt announcement on your analogue phone.
You should see the following login screen: The instructions are handdytone above. Please disconnect network cable and power cycle the unit before trying to reset the unit to factory defaults.
In order to prevent automatic posting on our website, we kindly request you to type in the number you see in the picture below. When booting the phone for the first time, please allow for minutes booting time as the phone might be automatically downloading and installing a new version of the firmware.
Grandstream Handytone Setup Make use of our Grandstream automated setup facility. Sending Fax from Zoiper to Zoiper using T.
If you are in static IP mode you can change the address. This value will change the default admin that was used to access the phone menu in step 2 above. Insert the Ethernet cable into the WAN port of HandyTone and connect the other end of the Ethernet cable to an uplink port a router or a modem, etc.
Introduction Grandstream HandyTone is a multi-port, all-in-one Analog telephone adapter. So we have to press: To do this, just enter 12 digits for the new IP address.
Handgtone very first time to access the configuration page is always from LAN port. The phone’s IP Address should appear on the phone’s screen.
Configure your SIP Registration settings as shown below: Find the MAC Address of the device. Set Admin Password to a personal value. Dial 02 and you should hear the IP Address.
Grandstream Handytone Setup Guide
Insert the power adapter into the HandyTone and connect it to a wall outlet. DO NOT include any leading zeros, so Let say, we want to enter for static IP address To test this dial How i fix this problems? You should hear a confirmation message played back to you. Select dynamically assigned via DHCP from the items below: Type the web address handytoje a web browser on a local PC.
It is a 12 digits HEX number located on the bottom side of the unit.
But how to enter the IP addresses? The configuration page should appear. I do apartcipee the writing. The device will reboot automatically and restore to factory default settings. Check these configuration instructions before continuing. Enter 9 to confirm the reset, or enter the MAC address to restore factory settings. This is not a mandatory step but we do recommend that you change the password. Insert a standard RJ11 telephone cable into the LINE port and connect the other end of the telephone cable to a wall jack.
Grandstream Handytone HT488 Analog Adapter
You will see the log in page of the device. Upon rebooting, your phone should have connected to the VoIPtalk service.
Asterisk News Archives older news.