WCDMA RAN Systems and Site Introduction. RBS components. WCDMA RBS Maintenance. 2. Customer Product Information (CPI) and. TXO Systems has the ERICSSON RBS RRUS 12 B3 in stock, along with a wide range of used and refurbished telecommunications equipment from all. Ericsson shall have no liability for any error or damage of any kind resulting from The support system for the RBS main unit is available in two variants.
|Published (Last):||9 November 2017|
|PDF File Size:||4.93 Mb|
|ePub File Size:||9.13 Mb|
|Price:||Free* [*Free Regsitration Required]|
This item may or may not be in original packaging. Unpack the TCU and verify that it is not damaged.
ERICSSON – RBS RRUS 12 B3 – TXO Systems
A Prolonged screwdriver is needed to reach the screws. Skip to main content. The following figure shows the procedure for making a V DC power connector. Never pull out the connector using the alarm wires. Support system variant 2 supports all DUW versions. Skip to main content. Erlcsson sure that the DC power supply cable has enough extra length to allow the removal of the main unit from the rack for service purposes without disconnecting the cable.
The TCU is installed in the slot 2 in the main unit. Connect cables to the TCU. Contact the seller – opens in a new window or tab and request a shipping method to your location.
Slot 2 is the upper eicsson in the main unit. Resume making your offerif the page does not update immediately. Image not available Photos not available for this variation.
Exhaust air from the rear may not be allowed to circulate to the front air intake in the rack. Enter number including dial code.
Ericsson RBS 6601 LTE Indoor Main Unit Remote Base Station 1/bfl 901 009/4
Make sure that the external DC power is switched off before connecting the cables. There are 3 items available. Delivery times may vary, especially during eriicsson periods.
The item you’ve selected was not added to your cart. This means ericssonn item has been inspected, cleaned, and repaired to full working order and is in excellent condition. Connect the longer Enclosure Control EC bus cable as follows: Select one of the following three options for connecting the on-site transmission system and go to the appropriate section: Seller assumes all responsibility for this listing.
Add to watch list Remove from watch list. Equipment that transmits laser light can cause permanent eye damage. Learn More – opens in a new window or tab Any international shipping is paid in part to Pitney Bowes Inc.
BTS FOR ERICSSON RBS – BFL /1 R3A – DUW 20 01 – KDU /2 R3B | eBay
Remove the protective caps from the connector on the cable and the DU. If so, remove the standard brackets and install the brackets that are supplied with the front cover. Do not twist the fiber to the minimum bending radius.
Estimated on or before Wed. For additional information, see the Global Shipping Program terms and conditions – opens in a new window or tab This amount includes applicable customs duties, taxes, brokerage and other fees.
ericsson rbs 6601
Other offers may also be available. Reinsert and tighten the hexagon screw to a torque of 15 Nm using a torque wrench and a 13 mm ericzson.
Once the power is switched on, the boards load with their specific software.